Operating System WK1 (110601wk1.zip)

Home / Operating System WK1 (110601wk1.zip)

Operating System WK1 (110601wk1.zip)

February 3, 2021 | | No Comments

================================================================
CHECK VERSION
===============================================================

TO CHECK OS: To check which Operating System version is loaded into the keyboard memory press MIDI/GENERAL then press PAGE> 10 times: the display shows “O.S. Release: gg-mm-aaaa”

RESET: To reset the instrument press at the same time the ‘UPPER 1’ key and the ‘1’, ‘2’ and ‘3’ number keypads.

================================================================
UPDATE SPECIFICATIONS
================================================================
Musical instrument:
GEM WK1
Update date:
11/06/01
Zipped File Name:
110601wk1.exe
Generated Files and size:
GMBOOT00.BIN (540.672 bytes)
================================================================
UPDATE FEATURES
================================================================
This is the first release.
================================================================
UPDATE INSTALLATION INSTRUCTIONS
================================================================
To update the Operating System, proceed as follows:
________________________________________________________________
A. SAVE USER PROGRAMMED DATA TO DISK
Updating the Instrument’s Operating System cancels all User Programmed Data present in RAM. Be sure to save all User Programmed Data to Disk before proceeding (see SAVE ALL procedure in the Disk Chapter of the owner’s manual).

This operation will NOT cancel the Flash Memory area !
________________________________________________________________
B. CREATE A NEW BOOT DISK
To create a New Boot Disk, proceed as follows:
1. Format a new 3.5 floppy disk in DOS format (1,44 MB).
2. Extract the OS into the formatted disk.
3. Write the date, (see Upgrade Specifications: Upgrade Date) on the disk’s
label.
________________________________________________________________
C. UPDATE THE OPERATING SYSTEM
To load the Operating System contained in the New Boot Disk:
1. Turn Off the instrument.
2. Insert the New Boot Disk in the drive.
3. Turn On the instrument.
4. When you see the message “Load Operating System?” press ENTER to start the Operating System update.
5. Wait while the Operating System is being loaded (you will see on the display the message “Loading!”).
6. Terminated loading the keyboard will restart with the new Operating System.
7. Remember to extract the Boot Disk and store it in a safe place.

Was this article helpful?
Dislike 0
Views: 0

About Author

about author

Dave Williams

Original and sole proprietor of GEMWorks Europe, later renamed to GEMClub - Generalmusic Owners Club.

Leave a Reply